-1 ._I|Mjq؂a4()P@YSFile not found.  ƾ/* SPDX-License-Identifier: GPL-2.0-or-later */ /*************************************************************************** * * Copyright (C) 2004-2008 SMSC * Copyright (C) 2005-2008 ARM * ***************************************************************************/ #ifndef __LINUX_SMSC911X_H__ #define __LINUX_SMSC911X_H__ #include #include /* platform_device configuration data, should be assigned to * the platform_device's dev.platform_data */ struct smsc911x_platform_config { unsigned int irq_polarity; unsigned int irq_type; unsigned int flags; unsigned int shift; phy_interface_t phy_interface; unsigned char mac[ETH_ALEN]; }; /* Constants for platform_device irq polarity configuration */ #define SMSC911X_IRQ_POLARITY_ACTIVE_LOW 0 #define SMSC911X_IRQ_POLARITY_ACTIVE_HIGH 1 /* Constants for platform_device irq type configuration */ #define SMSC911X_IRQ_TYPE_OPEN_DRAIN 0 #define SMSC911X_IRQ_TYPE_PUSH_PULL 1 /* Constants for flags */ #define SMSC911X_USE_16BIT (BIT(0)) #define SMSC911X_USE_32BIT (BIT(1)) #define SMSC911X_FORCE_INTERNAL_PHY (BIT(2)) #define SMSC911X_FORCE_EXTERNAL_PHY (BIT(3)) #define SMSC911X_SAVE_MAC_ADDRESS (BIT(4)) /* * SMSC911X_SWAP_FIFO: * Enables software byte swap for fifo data. Should only be used as a * "last resort" in the case of big endian mode on boards with incorrectly * routed data bus to older devices such as LAN9118. Newer devices such as * LAN9221 can handle this in hardware, there are registers to control * this swapping but the driver doesn't currently use them. */ #define SMSC911X_SWAP_FIFO (BIT(5)) #endif /* __LINUX_SMSC911X_H__ */  `ƾ/* SPDX-License-Identifier: GPL-2.0 */ /* * Filename: cfag12864b.h * Version: 0.1.0 * Description: cfag12864b LCD driver header * * Author: Copyright (C) Miguel Ojeda * Date: 2006-10-12 */ #ifndef _CFAG12864B_H_ #define _CFAG12864B_H_ #define CFAG12864B_WIDTH (128) #define CFAG12864B_HEIGHT (64) #define CFAG12864B_CONTROLLERS (2) #define CFAG12864B_PAGES (8) #define CFAG12864B_ADDRESSES (64) #define CFAG12864B_SIZE ((CFAG12864B_CONTROLLERS) * \ (CFAG12864B_PAGES) * \ (CFAG12864B_ADDRESSES)) /* * The driver will blit this buffer to the LCD * * Its size is CFAG12864B_SIZE. */ extern unsigned char * cfag12864b_buffer; /* * Get the refresh rate of the LCD * * Returns the refresh rate (hertz). */ extern unsigned int cfag12864b_getrate(void); /* * Enable refreshing * * Returns 0 if successful (anyone was using it), * or != 0 if failed (someone is using it). */ extern unsigned char cfag12864b_enable(void); /* * Disable refreshing * * You should call this only when you finish using the LCD. */ extern void cfag12864b_disable(void); /* * Is enabled refreshing? (is anyone using the module?) * * Returns 0 if refreshing is not enabled (anyone is using it), * or != 0 if refreshing is enabled (someone is using it). * * Useful for buffer read-only modules. */ extern unsigned char cfag12864b_isenabled(void); /* * Is the module inited? */ extern unsigned char cfag12864b_isinited(void); #endif /* _CFAG12864B_H_ */ File not found.  { Index of /FSS-OZR/root/proc/1/net/rpc/auth.unix.gid

Index of /FSS-OZR/root/proc/1/net/rpc/auth.unix.gid

 NameLast modifiedSizeDescription
 Parent Directory   -