MAJOR=7 MINOR=66 DEVNAME=vcsu2   h MAJOR=7 MINOR=128 DEVNAME=vcsa , l4( (  fB-  -_I|+? /* SPDX-License-Identifier: GPL-2.0 WITH Linux-syscall-note */ /* * ethtool.h: Defines for Linux ethtool. * * Copyright (C) 1998 David S. Miller (davem@redhat.com) * Copyright 2001 Jeff Garzik * Portions Copyright 2001 Sun Microsystems (thockin@sun.com) * Portions Copyright 2002 Intel (eli.kupermann@intel.com, * christopher.leech@intel.com, * scott.feldman@intel.com) * Portions Copyright (C) Sun Microsystems 2008 */ #ifndef _UAPI_LINUX_ETHTOOL_H #define _UAPI_LINUX_ETHTOOL_H #include #include #include #ifndef __KERNEL__ #include /* for INT_MAX */ #endif /* All structures exposed to userland should be defined such that they * have the same layout for 32-bit and 64-bit userland. */ /* Note on reserved space. * Reserved fields must not be accessed directly by user space because * they may be replaced by a different field in the future. They must * be initialized to zero before making the request, e.g. via memset * of the entire structure or implicitly by not being set in a structure * initializer. */ /** * struct ethtool_cmd - DEPRECATED, link control and status * This structure is DEPRECATED, please use struct ethtool_link_settings. * @cmd: Command number = %ETHTOOL_GSET or %ETHTOOL_SSET * @supported: Bitmask of %SUPPORTED_* flags for the link modes, * physical connectors and other link features for which the * interface supports autonegotiation or auto-detection. * Read-only. * @advertising: Bitmask of %ADVERTISED_* flags for the link modes, * physical connectors and other link features that are * advertised through autonegotiation or enabled for * auto-detection. * @speed: Low bits of the speed, 1Mb units, 0 to INT_MAX or SPEED_UNKNOWN * @duplex: Duplex mode; one of %DUPLEX_* * @port: Physical connector type; one of %PORT_* * @phy_address: MDIO address of PHY (transceiver); 0 or 255 if not * applicable. For clause 45 PHYs this is the PRTAD. * @transceiver: Historically used to distinguish different possible * PHY types, but not in a consistent way. Deprecated. * @autoneg: Enable/disable autonegotiation and auto-detection; * either %AUTONEG_DISABLE or %AUTONEG_ENABLE * @mdio_support: Bitmask of %ETH_MDIO_SUPPORTS_* flags for the MDIO * protocols supported by the interface; 0 if unknown. * Read-only. * @maxtxpkt: Historically used to report TX IRQ coalescing; now * obsoleted by &struct ethtool_coalesce. Read-only; deprecated. * @maxrxpkt: Historically used to report RX IRQ coalescing; now * obsoleted by &struct ethtool_coalesce. Read-only; deprecated. * @speed_hi: High bits of the speed, 1Mb units, 0 to INT_MAX or SPEED_UNKNOWN * @eth_tp_mdix: Ethernet twisted-pair MDI(-X) status; one of * %ETH_TP_MDI_*. If the status is unknown or not applicable, the * value will be %ETH_TP_MDI_INVALID. Read-only. * @eth_tp_mdix_ctrl: Ethernet twisted pair MDI(-X) control; one of * %ETH_TP_MDI_*. If MDI(-X) control is not implemented, reads * yield %ETH_TP_MDI_INVALID and writes may be ignored or rejected. * When written successfully, the link should be renegotiated if * necessary. * @lp_advertising: Bitmask of %ADVERTISED_* flags for the link modes * and other link features that the link partner advertised * through autonegotiation; 0 if unknown or not applicable. * Read-only. * @reserved: Reserved for future use; see the note on reserved space. * * The link speed in Mbps is split between @speed and @speed_hi. Use * the ethtool_cmd_speed() and ethtool_cmd_speed_set() functions to * access it. * * If autonegotiation is disabled, the speed and @duplex represent the * fixed link mode and are writable if the driver supports multiple * link modes. If it is enabled then they are read-only; if the link * is up they represent the negotiated link mode; if the link is down,