edge
!
Nam_J*j"TzqF
Index of /anon_sym/anon/proc/self/root/sys/class/tty/tty53
Index of /anon_sym/anon/proc/self/root/sys/class/tty/tty53
* l4(
( fB-
}=_I|+ & /* SPDX-License-Identifier: GPL-2.0-only */
/*
* Interface the generic pinconfig portions of the pinctrl subsystem
*
* Copyright (C) 2011 ST-Ericsson SA
* Written on behalf of Linaro for ST-Ericsson
* This interface is used in the core to keep track of pins.
*
* Author: Linus Walleij
*/
#ifndef __LINUX_PINCTRL_PINCONF_GENERIC_H
#define __LINUX_PINCTRL_PINCONF_GENERIC_H
#include
#include
struct device_node;
struct pinctrl_dev;
struct pinctrl_map;
/**
* enum pin_config_param - possible pin configuration parameters
* @PIN_CONFIG_BIAS_BUS_HOLD: the pin will be set to weakly latch so that it
* weakly drives the last value on a tristate bus, also known as a "bus
* holder", "bus keeper" or "repeater". This allows another device on the
* bus to change the value by driving the bus high or low and switching to
* tristate. The argument is ignored.
* @PIN_CONFIG_BIAS_DISABLE: disable any pin bias on the pin, a
* transition from say pull-up to pull-down implies that you disable
* pull-up in the process, this setting disables all biasing.
* @PIN_CONFIG_BIAS_HIGH_IMPEDANCE: the pin will be set to a high impedance
* mode, also know as "third-state" (tristate) or "high-Z" or "floating".
* On output pins this effectively disconnects the pin, which is useful
* if for example some other pin is going to drive the signal connected
* to it for a while. Pins used for input are usually always high
* impedance.
* @PIN_CONFIG_BIAS_PULL_DOWN: the pin will be pulled down (usually with high
* impedance to GROUND). If the argument is != 0 pull-down is enabled,
* if it is 0, pull-down is total, i.e. the pin is connected to GROUND.
* @PIN_CONFIG_BIAS_PULL_PIN_DEFAULT: the pin will be pulled up or down based
* on embedded knowledge of the controller hardware, like current mux
* function. The pull direction and possibly strength too will normally
* be decided completely inside the hardware block and not be readable
* from the kernel side.
* If the argument is != 0 pull up/down is enabled, if it is 0, the
* configuration is ignored. The proper way to disable it is to use
* @PIN_CONFIG_BIAS_DISABLE.
* @PIN_CONFIG_BIAS_PULL_UP: the pin will be pulled up (usually with high
* impedance to VDD). If the argument is != 0 pull-up is enabled,
* if it is 0, pull-up is total, i.e. the pin is connected to VDD.
* @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open
* collector) which means